Seagull Models MXS-R Manuel d'utilisateur télécharger pdf (Page 5)

5

www.seagullmodels.com

HINGING THE RUDDER.

Glue the rudder hinges in place using the

same techniques used to hinge the ailerons.

INSTALL THE AILERONS CONTROL

HORN.

Hinge.

2 sets.

3x35mm.

HINGING THE ELEVATOR.

Glue the elevator hinges in place using the

same techniques used to hinge the ailerons.

C/A glue.

1) Locate the hardware necessary to install

the control horns for the ailerons.

2) Position the control horn on the bottom of

the aileron. You will see pre-drill hole 6mm for

the horn mounting screw on the aileron.

3) Place epoxy into hole. This will harden the

threads and prevent the crews from pulling

loose.

4) Thread a control horn end with aluminum

washer, lock nut until the top edge of the end is

9mm from the vase of the horn as shown.

6mm.

6mm.

1 2 3 4 5 6 7 8 9 10 ... 37 38

Commentaires sur ces manuels

Pas de commentaire