Seagull Models PERCIVAL MEW GULL Spécifications

Made in VietnamMEW GULLKit features.• Ready-made—minimal assembly & finishing required.• Ready-covered covering.• Photo-illustrated step-by-step A

PERCIVAL MEW GULL Instruction Manual10Wheel.Axle.M3x10mm.Wheel collar.

www.seagullmodels.com11 1) Install the pushrod housing through thepredrilled hole in the firewall and into the servocompartment. The pushrod housing

PERCIVAL MEW GULL Instruction Manual124.2 mm2. Electric Conversion (Ep Power)

www.seagullmodels.com13Aluminum tube.Aluminum spacers.M6 x 120mm.M5 nut.M6x 120mm.Electric motor.150mmAAluminum spacers.Aluminum tube.BA4 sets.Aluminu

PERCIVAL MEW GULL Instruction Manual14Battery hatch2PenTrim and cut.Trim and cu

www.seagullmodels.com15THROTTLE SERVO ARM INSTALLATION. Install the switch into the precut hole in theside of fuselage.INSTALLING THE FUSELAGE SERVO

PERCIVAL MEW GULL Instruction Manual16Aileron.Wing.Wing.Aileron.Attach the stri

www.seagullmodels.com17 WING ASSEMBLY.M3 lock nut.Aileron.Repeat the procedure for the other wing.Aluminum tube diameter = 19 x 577

PERCIVAL MEW GULL Instruction Manual18Epoxy.Covering strip.Remove the covering.

www.seagullmodels.com19Epoxy.INSTALLING HORIZONTAL FIN.Aluminium tube diameter=12x208mm.3 x 70mm.CutFill epoxy.Epoxy.Epoxy.Epoxy.

PERCIVAL MEW GULL Instruction Manual2INTRODUCTION. Thank you for choosing

PERCIVAL MEW GULL Instruction Manual20ELEVATOR - RUDDER PUSHROD HORNINSTALLATIO

www.seagullmodels.com21 INSTALLING THE RECEIVER.Elevator.Elevator.Throttle.Rudder.A.A.Epoxy.A.C/A glue.Tie Wrap.Receiver.Antenna.

PERCIVAL MEW GULL Instruction Manual22FLIGHT PREPARATION.  A) Check the o

www.seagullmodels.com23 2) Check every bolt and every glue jointin the PERCIVAL MEWGULL to ensure thateverything is tight and well bonded.  E)Chec

www.seagullmodels.com3 1) Carefully remove the aileron from one ofthe wing panels. Note the position of the hinges. 2) Remove each hinge from the wi

PERCIVAL MEW GULL Instruction Manual4HINGING THE ELEVATOR. 8) After both aile

www.seagullmodels.com518mm.EPOXY.HorizontalStabilizer. Elevator.ELEVATOR CONTROL HORN. Install the elevator control horn using thesame method as with

PERCIVAL MEW GULL Instruction Manual6 2) Using a modeling knife, cut one lengt

www.seagullmodels.com7 4) Test fit the stopper assembly into thetank. It may be necessary to remove some ofthe flashing around the tank opening usin

PERCIVAL MEW GULL Instruction Manual8 2) Insert the 90o bend of one main ge

www.seagullmodels.com9ABM3 x 10mm.Trim and cut.