Seagull Models MXS-R Manuel d'utilisateur télécharger pdf (Page 3)

3

www.seagullmodels.com

ADDITIONAL ITEMS REQUIRED.

 0.91-1.2 2-stroke.

1.00-1.25 4-stroke.

 Computer radio with 5 servos.

 Glow plug to suit engine.

 Propeller to suit engine.

 Protective foam rubber for radio

system.

 Silicone fuel line.

TOOLS & SUPPLIES NEEDED.

 Thick cyanoacrylate glue.

 30 minute epoxy.

 5 minute epoxy.

 Hand or electric drill.

 Assorted drill bits.

 Modelling knife.

 Straight edge ruler.

 2mm ball driver.

 Phillips head screwdriver.

 220 grit sandpaper.

 90° square or builder’s triangle.

 Wire cutters.

 Masking tape & T-pins.

 Thread-lock.

 Paper towels.

The control surfaces, including the

ailerons, elevators, and rudder, are

prehinged with hinges installed, but

the hinges are not glued in place. It

is imperative that you properly

adhere the hinges in place per the

steps that follow using a high-quality

thin C/A glue.

 2) Remove each hinge from the wing panel

and aileron and place a T-pin in the center of

each hinge. Slide each hinge into the aileron

until the T-pin is snug against the aileron. This

will help ensure an equal amount of hinge is

on either side of the hinge line when the aileron

is mounted to the wing panel.

HINGING THE AILERONS .

Note:

Hinge.

T-pin.

KIT CONTENTS.

1 Fuselage

2 Canopy

3 Left wing panel

4 Right wing panel

5 Tail set

6 Aluminum wing tube

7 Scale pilot

8 Fiberglass cowl

9 Wheel pants (2)

10 Main landing gear

11 EP conversion pack

12 Hardware bag included

 3) Slide the aileron on the wing panel until

there is only a slight gap. The hinge is now

centered on the wing panel and aileron.

Remove the T-pins and snug the aileron

against the wing panel. A gap of 1/64” or less

should be maintained between the wing panel

and aileron.

 1) Carefully remove the aileron from one

of the wing panels. Note the position of the

hinges.

1 2 3 4 5 6 7 8 ... 37 38

Commentaires sur ces manuels

Pas de commentaire