Seagull Models Funfly 3D Spécifications télécharger pdf (Page 5)

5

www.seagullmodels.com

2) Position the control horn on the bottom of

the aileron. You will see pre-drill hole 3mm for

the horn mounting screw on the aileron.

2 sets.

3x35mm.

Aileron control horn.

3) Place epoxy into hole. This will harden the

threads and prevent the crews from pulling

loose.

4) Thread a control horn end with aluminum

washer, lock nut until the top edge of the end is

18mm from the vase of the horn as shown.

3mm.

ALUMINUM WASHER.

ALUMINUM WASHER.

CONTROL HORN

M3 SCREW.

18mm.

Epoxy.

Wing

Wing

Epoxy.

M3 LOCK NUT.

3mm.

Install the elevator control horn using the

same method as same as the aileron control

horns.

INSTALL ELEVATOR CONTROL HORN.

2 sets.

3x35mm.

Aluminum Washer.

CONTROL HORN M3

M3 LOCK NUT.

Epoxy.

Aluminum Washer.

Horizontal

Stabilizer.

Elevator.

1 2 3 4 5 6 7 8 9 10 ... 23 24

Commentaires sur ces manuels

Pas de commentaire