Seagull Models Funfly 3D Spécifications Page 1

“Graphics and specifications may change without notice”.MS:40ASSEMBLY MANUALSpecifications:Wing span ----------------------------50.4in (128cm).

SEAGULL FUNFLY 3D. Instruction Manual.10THROTTLE SERVO ARM INSTALLATION. Install ad

11www.seagullmodels.comSwitch.3/ 32” Hole.INSTALLING THE SWITCH.Install the switch into the precut hole in theside, in the fuselage.Trim and cut.INS

SEAGULL FUNFLY 3D. Instruction Manual.123) Use a drill to drill the four holes in t

13www.seagullmodels.com9) Move the throttle stick to the closed positionand move the carburetor to closed. Use a 1.5mmhex wrench to tighten the

SEAGULL FUNFLY 3D. Instruction Manual.143) Install the muffler and muffler extens

15www.seagullmodels.com2) Attach the electric motor box to the firewallsuitable with the cross lines drawn on the electricmotor box and firew

SEAGULL FUNFLY 3D. Instruction Manual.16INSTALLING THE HORIZONTAL STABILIZER. 1) Us

17www.seagullmodels.com 6) With the stabilizer held firmly in place,use a pen and draw lines onto the stabilizerwhere it and the fuselage sides meet.

SEAGULL FUNFLY 3D. Instruction Manual.18HINGING THE ELEVATOR.Epoxy. 1) Carefully r

19www.seagullmodels.com 5) Slide the vertical stabilizer back inplace. Using a triangle, check to ensure thatthe vertical stabilizer is aligned

SEAGULL FUNFLY 3D. Instruction Manual.2INTRODUCTION.Thank you for choosing the S E

SEAGULL FUNFLY 3D. Instruction Manual.20ELEVATOR AND RUDDERPUSHROD HORN INSTALLAT

21www.seagullmodels.com3) Mark where you drill the two locationsfor the tailwheel support.Elevator pushrod.Rudder pushrod.M3 lock nut.M3 clevis. 11

SEAGULL FUNFLY 3D. Instruction Manual.224) Drill through the bottom of the rudder

23www.seagullmodels.comBALANCING.  1) It is critical that your airplane bebalanced correctly. Improper balance willcause your plane to l

SEAGULL FUNFLY 3D. Instruction Manual.24*If possible, first attempt to balance the m

3www.seagullmodels.comADDITIONAL ITEMS REQUIRED. 0.46-0.55 2-stroke. 0.72 4-stroke. Computer radio w

SEAGULL FUNFLY 3D. Instruction Manual.4INSTALL THE AILERONS CONTROLHORN.1) Locat

5www.seagullmodels.com2) Position the control horn on the bottom ofthe aileron. You will see pre-drill hole 3mm forthe horn mounti

SEAGULL FUNFLY 3D. Instruction Manual.6Thread locker glue.ENGINE MOUNT INSTALLATION.

7www.seagullmodels.com 1) Using a modeling knife, carefully cutoff the rear portion of one of the 3 nylon tubesleaving 1/2” protruding from the rear

SEAGULL FUNFLY 3D. Instruction Manual.87) Slide the fuel tank into the fuselage.

9www.seagullmodels.comC/A glue.Landing Gear.wheel Pant.wheel Pant.wheel.M3.M3.wheel collar.nut.Axle.Washer. 3) A drop of C/A glue on the wheel