Seagull Models Ultimate Spécifications télécharger pdf (Page 12)

ULTIMATE. Instruction Manual.

12

Pushrod wire.

4x30mm.

 4) Remove the engine. Using an drill bit,

drill the mounting holes through the engine

mount at the four locations marked.

 3) When you are satisfied with the align-

ment, mark the locations of the engine

mounting.

 6) Attach the Z-Bend in the pushrod wire to

the throttle arm on the carburetor.

 5) Bolt the engine to the engine mount using

the four machine screws. Double check that

all the screws are tight before proceeding.

2mm.

3x25mm.

Because of the size of the cowl, it may be

necessary to use a needle valve extension for

the high speed needle valve. Make this out of

sufficient length 1.5mm wire and install it into

the end of the needle valve. Secure the wire

in place by tightening the set screw in the side

of the needle valve.

3x10mm.

Trim and cut.

 2) While keeping the back edge of the

cowl flush with the marks, align the front of

the cowl with the crankshaft of the engine. The

front of the cowl should be positioned so the

crankshaft is in nearly the middle of the cowl

opening. Use the spinner backplate as a guide.

Hold the cowl firmly in place using pieces of

masking tape.

115mm.

COWLING.

 1) Slide the fiberglass cowl over the en-

gine and line up the back edge of the cowl with

the marks you made on the fuselage then trim

and cut.

 2) Place your engine onto the engine

mount. Adjust the engine is centered of the

edges of the engine case.

1 2 ... 7 8 9 10 11 12 13 14 15 16 17 ... 23 24

Commentaires sur ces manuels

Pas de commentaire